TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-03 Right Steering Cyl-
2. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
inder Position Sensor Volt-
sure resistance between right
Front chassis wiring harness is open,
age Above Normal -
steering cylinder position sensor
replace front chassis wiring harness
Continued
wiring harness connector UC-C1
(WP 0180).
(WP 0009, Figure 198) terminal 3
Remove jumper wire between UC-C2
and machine ground.
(WP 0009, Figure 196) terminal 2 and
Resistance should be less than
machine ground.
5.0 Ohms.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C22 (WP 0009,
Figure 47) to cab lower wiring harness
P-C69 (WP 0009, Figure 46).
Proceed to step 3.
0031-55
