TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-03 Right Steering Cyl-
System Response:
inder Position Sensor Volt-
ECM will log a diagnostic code and a
age Above Normal
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
codes and Front End Alignment.
1. Connect MSD (WP 0006), select
0041-02 or 0041-03 Implement ECM
implement 120M and check for
Code Active - Troubleshoot 1482-02
Active code 0041-02 or 0041-03.
or 1482-03 code first before
proceeding.
0041-02 or 0041-03 Code Not Active
- Proceed to step 2.
2201-03 Code Active - Proceed to
2. Using the MSD (WP 0006), select
Test Step 2.
Trans/chassis 120M and verify
2201-03 is active.
2201-03 Code Active - Repeat
3. Using the MSD (WP 0006), select
troubleshooting code from the
Trans/chassis 120M and verify
beginning.
2201-03 is not active.
2201-03 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
0031-50