TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-02 Right Steering Cyl- Test Step 7. Test for Open Cab
inder Position Sensor Data
Lower Wiring Harness to Imple-
Erratic, Intermittent or Incor- ment ECM.
rect - Continued
1. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between cab
Replace transmission ECM (WP
lower wiring harness connector P-
0137).
C39 (WP 0009, Figure 70) termi-
Remove jumper wire between UC-C2
nal 16 and machine ground.
(WP 0009, Figure 196) terminal 2 and
Resistance should be less than
machine ground.
5.0 Ohms.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Remove jumper wire between UC-C2
(WP 0009, Figure 196) terminal 2 and
machine ground.
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select 2201-02 Code Active - Repeat
Implement 120M and verify 2201- troubleshooting code from the
02 is not active.
beginning.
2201-02 Code Not Active -
Troubleshooting complete.
0031-49
