TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-08 Left Steering Cylin-
2. Using the MSD (WP 0006), select 2200-08 Code Active - Repeat
der Position Sensor Abnor-
Implement 120M and verify 2200- troubleshooting code from the
mal Frequency, Pulse Width
08 is not active.
beginning.
or Period - Continued
2200-08 Code Not Active -
Troubleshooting complete.
System Response:
2200-14 Left Steering Cylin-
der Position Sensor Special
ECM will log a diagnostic code and a
Instruction
warning will appear on the messenger
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
codes and Front End Alignment.
1. Connect MSD (WP 0006), select
Implement 120M and verify 2200-
14 is active.
2. Perform Axle Toe-In (Front)
Toe-In is Correct - Proceed to Test
Adjust (WP 0044).
Step 2.
Toe-In Required Adjustment -
Proceed to step 3.
3. Using the MSD (WP 0006), select 2200-14 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
14 is not active.
beginning.
2200-14 Code Not Active -
Troubleshooting complete.
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the steering position
sensor harness UA-C2 (WP 0009,
Figure 192) from left steering
position sensor (WP 0009, Figure
193) (WP 0169).
0031-39
