TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-03 Left Steering Cylin-
Test Step 5. Test for Open Front
der Position Sensor Voltage
Chassis Wiring Harness.
Above Normal - Continued
1. Disconnect the front chassis wir-
ing harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness P-C151 (WP
0009, Figure 189) (WP 0180).
Resistance Less Than 5.0 Ohms -
sure resistance between front
Cab lower wiring harness is open,
chassis wiring harness connector
replace cab lower wiring harness (WP
U-C36 (WP 0009, Figure 188) ter-
0266).
minal 2 and terminal 6.
Remove jumper wire between UA-C2
(WP 0009, Figure 192) terminal 2 and
5.0 Ohms.
terminal 3.
Connect the rear chassis wiring
harness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
Proceed to Test Step 6.
3. Using the MSD (WP 0006), select 2200-03 Code Active - Repeat
Implement 120M and verify 2200- troubleshooting code from the
03 is not active.
beginning.
2200-03 Code Not Active -
Troubleshooting complete.
Test Step 6. Test for Open Front
Chassis Wiring Harness.
1. Disconnect the left steering cylin-
der position sensor wiring har-
ness connector UA-C1 (WP 0009,
Figure 194) from front attachment
wiring harness U-C51 (WP 0009,
Figure 195) (WP 0136).
0031-14