TM 5-3805-293-23-2
0031
Table 1. Implement Code (2200-00 TO 2954-14) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-03 Left Steering Cylin-
3. Disconnect UC-C2 (WP 0009,
der Position Sensor Voltage
Figure 196) from left steering
Above Normal - Continued
position sensor (WP 0009, Figure
193).
4. Connect the steering position
sensor harness UC-C2 (WP
0009, Figure 196) to right steering
position sensor (WP 0009, Figure
197) (WP 0169).
5. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
6. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
7. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
8. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
9. Connect jumper wire between
UA-C2 (WP 0009, Figure 192)
terminal 2 and terminal 3.
10. Using a digital multimeter, mea-
Resistance Less Than 5.0 Ohms -
sure resistance between rear
Proceed to Test Step 7.
chassis wiring harness connector
Resistance 5.0 Ohms or Greater -
FA-C21 (WP 0009, Figure 124)
Proceed to Test Step 4.
terminal 15 and FA-C20 (WP
0009, Figure 113) terminal 70.
Resistance should be less than
5.0 Ohms.
0031-12