TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2153-03 Blade Pitch Control
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
Position Sensor Voltage
for continuity between cab lower
Replace rear chassis wiring harness
Above Normal - Continued
wiring harness connector P-C71
(WP 0188) and cab lower wiring
(WP 0009, Figure 18) terminal 1
harness (WP 0266).
and terminal 2.
Proceed to step 3.
Resistance should be less than
Resistance 5.0 Ohms or Greater -
5.0 ohms.
Replace cab lower wiring harness
(WP 0266).
Connect the rear chassis wiring
harness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using MSD (WP 0006), select
2153-03 Code Active - Repeat
Implement 120M ECM and verify
troubleshooting code from the
2153-03 is not active.
beginning.
2153-03 Code Not Active -
Troubleshooting complete.
Test Step 5. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
3. Connect jumper wire between cab
lower wiring harness connector
PE-C8 (WP 0009, Figure 50) ter-
minal 1 and terminal 3.
0028-51