TM 5-3805-293-23-2
0028
Table 1. Implement Code (2146-02 to 2156-08) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2152-08 Wheel Lean Control
6. Using MSD (WP 0006), select
2152-08 Code Active - Repeat
Position Sensor Abnormal
Implement 120M ECM and verify
troubleshooting code from the
Frequency, Pulse Width or
2152-08 is not active.
beginning.
Period - Continued
2152-08 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Connect jumper wire between cab
lower wiring harness connector P-
C52 (WP 0009, Figure 154) termi-
nal 2 and P-C48 (WP 0009, Fig-
ure 116) terminal 3.
3. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J1 (WP 0009, Figure 69)
(WP 0266).
4. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J2 (WP 0009, Figure 71)
(WP 0266).
5. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
for continuity between cab lower
Replace implement 1 ECM (WP
wiring harness connector P-C39
0268).
(WP 0009, Figure 70) terminal 24
Remove jumper wire between cab
and P-C41 (WP 0009, Figure 68)
lower wiring harness connector P-C52
terminal 21.
(WP 0009, Figure 154) terminal 2 and
Resistance should be less than
P-C48 (WP 0009, Figure 116) terminal
5.0 ohms.
3.
Connect cab lower wiring harness
connector P-C52 (WP 0009, Figure
154) to LH joystick connector J2 (WP
0282).
Connect cab lower wiring harness
connector P-C48 (WP 0009, Figure
116) to LH joystick connector J3 (WP
0282).
Proceed to step 6.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Proceed to step 6.
0028-48
