TM 5-3805-293-23-2
0027
Table 1. Implement Code (0615-02 TO 2113-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1472-03 Steering Control
2. Connect jumper wire between P-
Position Sensor #2 Voltage
C51 terminal 1 and terminal 8
Above Normal - Continued
(WP 0009, Figure 118).
3. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
4. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between P-C41 (WP
Replace implement 1 ECM (WP
0009, Figure 68) terminal 44 and
0268).
terminal 45 (WP 0009, Figure 18).
Remove jumper wire between P-C51
Resistance should be less than
terminal 1 and terminal 8 (WP 0009,
5.0 ohms.
Figure 118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Proceed to step 5.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Proceed to step 5.
5. Using the MSD (WP 0006), select 1472-03 Code Active - Repeat
Implement 120M and verify 1472- troubleshooting code from the
03 is not active.
beginning.
1472-03 Code Not Active -
Troubleshooting complete.
Test Step 3. Test for Shorted Rear
Chassis Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
3. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
0027-79
