TM 5-3805-293-23-2
0026
Table 1. Implement Code (0041-03 to 0600-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
7. Using digital multimeter, test for
0041-03 8 Volt DC Supply
Continuity - Proceed to Test Step 2.
continuity between harness con-
Voltage Above Normal -
No Continuity - Proceed to step 8.
nector FA-C20 (WP 0009, Figure
Continued
113) terminal 44 and all other ter-
minals on FA-C20.
There should be no continuity.
8. Remove inching pedal assembly
cover (WP 0290).
9. Disconnect harness connector P-
C40 (WP 0009, Figure 144) from
inching pedal position sensor (WP
0009, Figure 145) (WP 0290).
10. Remove operator's seat (WP
0284).
11. Remove inner panel cover from
left joystick support (WP 0282).
12. Disconnect harness connector P-
C48 (WP 0009, Figure 116) from
left hand joystick J3 (WP 0009,
Figure 117) (W 0217).
13. Using digital multimeter, test for
Continuity - 8 Volt supply circuit is
continuity between harness con-
shorted. Replace cab lower wiring
nector P-C71 (WP 0009, Figure
harness (WP 0266).
18) terminal 6 and all other termi-
Connect harness connector FA-C20
nals on P-C71.
(WP 0009, Figure 113) to
There should be no continuity.
transmission ECM J1(WP 0137).
Connect harness connector AT-C4
(WP 0009, Figure 122) to right
articulation angle position sensor (WP
0009, Figure 123) (WP 0257), and
install pedal assembly cover (WP
0290).
Proceed to step 19.
No Continuity - Proceed to step 14.
14. Connect harness connector FA-
C23 (WP 0009, Figure 17) to har-
ness connector P-C71 (WP 0009,
Figure 18) (WP 0188).
15. Connect harness connector FA-
C20 (WP 0009, Figure 113) to
transmission ECM J1 (WP 0137).
N OT E
Other diagnostic codes may set during this procedure. Allow at least 30
seconds for the diagnostic code to become active.
0026-3