TM 5-3805-293-23-2
0024
Table 1. Window Wipers and Washers Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3. RH Door Wiper Does Not
2. Using digital multimeter, measure
Resistance 5.0 Ohms or Greater -
Operate Properly - Con-
resistance between WJ-C2 termi-
Replace wiper wiring harness (WP
tinued
nal 5 (WP 0009, Figure 366) and
0292).
WJ-C1 terminal D (WP 0009, Fig-
Connect R-C32 (WP 0009, Figure
ure 365).
363) on RH door wiper washer switch
(WP 0274).
Proceed to step 3.
Resistance Less Than 5.0 Ohms -
Replace RH door wiper motor (WP
0259).
Connect cab upper wiring harness
connector R-C13 (WP 0009, Figure
364) to wiper harness connector WJ-
C1 (WP 0009, Figure 365) (WP 0265).
Connect R-C32 (WP 0009, Figure
363) on RH door wiper washer switch
(WP 0274).
Proceed to step 3.
3. Turn battery disconnect switch
and ignition switch to ON position
(TM 5-3805-293-10).
4. Turn right door wiper/washer con- Right Door Wiper Does Not Work in
One Or More Positions Or Does Not
trol to LOW, HIGH, and PARK
Return To Park - Repeat trouble-
position (TM 5-3805-293-10).
shooting from beginning.
Right Door Wiper Works In Low,
and High Position, and Returns to
Park - Troubleshooting complete.
Test Step 24. Test 527-GN Low
Speed Circuit for High Resistance
or Open in Cab Upper Wiring Har-
ness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-293-10).
2. Disconnect cab upper wiring har-
ness connector R-C32 (WP 0009,
Figure 363) from LH door wiper
washer switch.
3. Connect cab upper wiring har-
ness connector R-C31 (WP 0009,
Figure 367) on LH door wiper
washer switch (WP 0274).
0024-73