TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2304-05 Differential Lock
System Response:
Relay Current Below Normal ECM will log a diagnostic code.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is active.
Test Step 1. Verify if Code 2304-05
is Active.
1. Using MSD (WP 0006). Select
2304-05 Code Active - Proceed to
Trans/Chassis 120M and verify
Test Step 2.
2304-05 is active for the
2304-05 Code Not Active - Trouble-
transmission ECM or the
shooting complete.
Implement 1 ECM.
Test Step 2. Test for Faulty Differen-
tial Lock Relay.
1. Turn ignition switch and battery
disconnect switch to the OFF
position (TM 5-3805-293-10).
2. Remove the differential lock relay
(WP 0009, Figure 200) from dif-
ferential lock relay socket (WP
0009, Figure 199).
3. Using digital multimeter, measure
Resistance 288 to 396 Ohms - Pro-
resistance between differential
ceed to Test Step 3.
lock relay (WP 0009, Figure 200)
Resistance Not 288 to 396 Ohms -
terminal 86 and terminal 85.
Replace differential lock relay (WP
Resistance should be 288 to 396
0009, Figure 200).
Ohms.
Proceed to step 4.
4. Connect MSD (WP 0006). Select
2304-05 Code Active - Repeat trou-
Trans/Chassis 120M and verify
bleshooting from the beginning of this
2304-05 is active.
diagnostic code.
2304-05 Code Not Active - Trouble-
shooting complete.
0020-147