TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2201-03 Right Steering Cyl-
Test Step 12. Test for Shorted Cab
inder Position Sensor Volt-
Lower Wiring Harness to Imple-
age Above Normal -
ment ECM.
Continued
1. Using digital multimeter, measure
resistance between cab lower wir-
Continuity - Cab lower wiring har-
ing harness connector P-C39
ness is shorted, replace cab lower wir-
(WP 0009, Figure 70) terminal 16
ing harness (WP 0266).
and all other P-C39 terminals.
Connect the steering position sensor
There should be no continuity.
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 2.
No Continuity - Replace transmis-
sion ECM (WP 0137).
Connect the steering position sensor
harness UC-C2 (WP 0009, Figure
196) to right steering position sensor
(WP 0009, Figure 197) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
2. Using the MSD (WP 0006), select
2201-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2201-03 is not active.
2201-03 Code Not Active - Trouble-
shooting complete.
0020-96
