TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-08 Left Steering Cylin-
Test Step 7. Test for Open Cab
der Position Sensor Abnor-
Lower Wiring Harness to Imple-
ment ECM.
or Period - Continued
resistance between cab lower wir-
Replace transmission ECM (WP
ing harness connector P-C39
0137).
(WP 0009, Figure 70) terminal 15
Remove jumper wire from UA-C2 (WP
and P-C41 (WP 0009, Figure 68)
0009, Figure 192) terminal 2 and ter-
terminal 70. Resistance should be
minal 3.
less than 5.0 Ohms.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C41 (WP 0009, Figure
68) to implement ECM J-1 (WP 0009,
Figure 69) (WP 0268).
Proceed to step 2.
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Remove jumper wire from UA-C2 (WP
0009, Figure 192) terminal 2 and ter-
minal 3.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 2.
2. Using the MSD (WP 0006), select
2200-08 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-08 is not active.
2200-08 Code Not Active - Trouble-
shooting complete.
0020-73