TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-08 Left Steering Cylin-
Test Step 5. Test for Open Front
der Position Sensor Abnor-
Attachment Wiring Harness.
mal Frequency, Pulse Width
1. Disconnect the front attachment
or Period - Continued
wiring harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness P-C151 (WP
0009, Figure 189) (WP 0180).
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between front attach-
Cab lower wiring harness is open,
ment wiring harness connector U-
replace cab lower wiring harness (WP
C36 (WP 0009, Figure 188) termi-
0266).
nal 2 and terminal 6. Resistance
Remove jumper wire from UA-C2 (WP
should be less than 5.0 Ohms.
0009, Figure 192) terminal 2 and ter-
minal 3.
Connect the steering position sensor
harness UA-C2 (WP 0009, Figure
192) to left steering position sensor
(WP 0009, Figure 193) (WP 0169).
Connect the rear chassis wiring har-
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) (WP 0154) to transmis-
sion ECM J1 (WP 0009, Figure 112).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 6.
3. Using the MSD (WP 0006), select
2200-08 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-08 is not active.
2200-08 Code Not Active - Trouble-
shooting complete.
0020-70