TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2199-08 Secondary Steering
2. Using the MSD (WP 0006), select
2199-08 Code Active - Repeat trou-
Request Signal Line Abnor-
Trans/chassis 120M and verify
bleshooting code from the beginning.
mal Frequency, Pulse Width
2199-08 is not active.
2199-08 Code Not Active - Trouble-
or Period - Continued
shooting complete.
2200-02 Left Steering Cylin-
System Response:
der Position Sensor Data
ECM will log a diagnostic code and a
Erratic, Intermittent or Incor-
warning will appear on the messenger
rect
while the diagnostic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a con-
nection is found, correct the problem and verify that this diagnostic code
is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for other active
codes and Front End Alignment.
1482-02 or 1482-03 Code Active -
1. Connect MSD (WP 0006), select
Troubleshoot 1482-02 or 1482-03
Trans/chassis 120M and check
code first before proceeding.
for Active code 1482-03 or 1482-
03.
1482-02 or 1482-03 Code Not Active
- Proceed to step 2.
2. Connect MSD (WP 0006), select
Trans/chassis 120M and verify
2200-02 is active.
3. Perform Axle Toe-In (Front)
Toe-In is Correct - Proceed to Test
Adjust (WP 0044).
Step 2.
Toe-In Required Adjustment - Pro-
ceed to step 4.
4. Using the MSD (WP 0006), select
2200-02 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2200-02 is not active.
2200-02 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test for Faulty Left
Steering Cylinder Position Sensor.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
0020-38
