TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2200-02 Left Steering Cylin- 2.
Disconnect UA-C2 (WP 0009,
der Position Sensor Data
Figure 192) from right steering
Erratic, Intermittent or Incor-
position sensor (WP 0009, Figure
rect - Continued
197).
3. Disconnect UC-C2 (WP 0009,
Figure 196) from left steering
position sensor (WP 0009, Figure
193).
4. Connect the steering position
sensor harness UC-C2 (WP
0009, Figure 196) to right steering
position sensor (WP 0009, Figure
197) (WP 0169).
5. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J1 (WP 0009, Fig-
ure 112).
6. Disconnect the rear chassis wir-
ing harness connector FA-C21
(WP 0009, Figure 124) from
transmission ECM J2 (WP 0009,
Figure 112).
7. Disconnect the cab lower wiring
harness connector P-C39 (WP
0009, Figure 70) from implement
ECM J-2 (WP 0009, Figure 71)
(WP 0268).
8. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
9. Connect jumper wire between
UA-C2 (WP 0009, Figure 192) ter-
minal 2 and terminal 3.
resistance between rear chassis
Proceed to Test Step 7.
wiring harness connector FA-C21
(WP 0009, Figure 124) terminal
Proceed to Test Step 4.
15 and FA-C20 (WP 0009, Figure
113) terminal 70. Resistance
should be less than 5.0 Ohms.
0020-40