TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2199-03 Secondary Steering
Test Step 2. Test for Open Rear
Request Signal Line Voltage
Chassis Wiring Harness.
Above Normal - Continued
1. Disconnect the rear chassis wir-
ing harness FA-C22 (WP 0009,
Figure 47) from cab lower wiring
harness connector P-C69 (WP
0009, Figure 46) (WP 0266).
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between P-C69 (WP
Replace cab lower wiring harness
0009, Figure 46) terminal 12 and
(WP 0266).
machine ground. Resistance
Connect the rear chassis wiring har-
should be less than 5.0 Ohms.
ness connector FA-C21 (WP 0009,
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Replace rear chassis wiring harness
(WP 0188).
Remove jumper wire from cab lower
wiring harness connector P-C39 (WP
0009, Figure 70) terminal 19 and
machine ground.
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2199-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2199-03 is not active.
2199-03 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test for Shorted Rear
Chassis Wiring Harness.
1. Remove jumper wire between cab
lower wiring harness connector P-
C39 (WP 0009, Figure 70) termi-
nal 19 and machine ground.
0020-32