TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2176-05 Secondary Steer
2. Using digital multimeter, test for
Resistance Less Than 5.0 Ohms -
Right Solenoid Current
resistance between cab lower wir-
Rear chassis wiring harness is open,
Below Normal - Continued
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 14
(WP 0188).
and terminal 18. Resistance
Remove jumper wire from front
should be less than 5.0 Ohms.
attachment wiring harness connector
U-C40 (WP 0009, Figure 190)) termi-
nal 1 and terminal 2.
Connect the front attachment wiring
harness connector U-C40 (WP 0009,
Figure 190)) to secondary steering
right solenoid (WP 0009, Figure 191)
(WP 0216).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Proceed to Test Step 4.
3. Using the MSD (WP 0006), select
2176-05 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2176-05 is not active.
2176-05 Code Not Active - Trouble-
shooting complete.
Test Step 4. Test for Open Front
Attachment Wiring Harness.
1. Disconnect the front attachment
wiring harness connector U-C36
(WP 0009, Figure 188) from cab
lower wiring harness connector P-
C151 (WP 0009, Figure 189).
0020-26
