TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-03 Operator In-Seat
Test Step 5. Test for Open Cab
Switch Voltage Above Nor-
Lower Wiring Harness.
mal - Continued
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
2. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between cab lower wir-
Rear chassis wiring harness is open,
ing harness connector P-C69
replace rear chassis wiring harness
(WP 0009, Figure 46) terminal 67
(WP 0188).
and terminal 16. Resistance
Remove jumper wire from cab lower
should be less than 5.0 Ohms.
wiring harness connector P-C2 (WP
0009, Figure 184) terminal A and ter-
minal C.
Connect the cab lower wiring harness
connector P-C2 (WP 0009, Figure
184) to operator in-seat switch (WP
0009, Figure 185) (WP 0284).
Proceed to step 3.
Resistance 5.0 Ohms or Greater -
Cab lower wiring harness is open,
replace cab lower wiring harness (WP
0266).
Connect the rear chassis wiring har-
ness connector FA-C20 (WP 0009,
Figure 113) to transmission ECM J-1
(WP 0009, Figure 112).
Proceed to step 3.
3. Using the MSD (WP 0006), select
2113-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
2113-03 is not active.
2113-03 Code Not Active - Trouble-
shooting complete.
Test Step 6. Test for Shorted Rear
Chassis Wiring Harness.
1. Remove jumper wire between cab
lower wiring harness connector P-
C2 (WP 0009, Figure 184) termi-
nal A and terminal C.
2. Using digital multimeter, measure
Continuity - Proceed to Test Step 7.
continuity between rear chassis
No Continuity - Proceed to Test Step
wiring harness connector FA-C20
8.
(WP 0009, Figure 113) terminal
63 and all other FA-C20 terminals.
There should be no continuity.
0020-5
