TM 5-3805-293-23-2
0020
Table 1. Transmission Code (2113-03 TO 2304-06) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2113-03 Operator In-Seat
6. Using the MSD (WP 0006), select
2113-03 Code Active - Repeat trou-
Switch Voltage Above Nor-
Trans/chassis 120M and verify
bleshooting code from the beginning.
mal - Continued
2113-03 is not active.
2113-03 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test for Open Rear
Chassis Wiring Harness to Trans/
Chassis ECM.
1. Connect jumper wire between cab
lower wiring harness connector P-
C2 (WP 0009, Figure 184) termi-
nal A and terminal B.
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) from trans-
mission ECM J-1 (WP 0009, Fig-
ure 112).
3. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between rear chassis
Proceed to Test Step 4.
wiring harness connector FA-C20
Resistance 5.0 Ohms or Greater -
(WP 0009, Figure 113) terminal
Proceed to Test Step 3.
63 and terminal 70. Resistance
should be less than 5 Ohms.
Test Step 3. Test for Open Cab
Lower Wiring Harness.
1. Disconnect the rear chassis wir-
ing harness connector FA-C22
(WP 0009, Figure 47) from cab
lower wiring harness connector P-
C69 (WP 0009, Figure 46).
0020-3