TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-03 Steering Control
2. Using digital multimeter, test for
Continuity - Cab lower wiring har-
Position Sensor #1 Voltage
continuity between cab lower wir-
ness is shorted, replace cab lower wir-
Above Normal - Continued
ing harness connector P-C69
ing harness (WP 0266).
(WP 0009, Figure 46) terminal 49,
Connect the rear chassis wiring har-
and all other terminals. There
ness connector FA-C21 (WP 0009,
should be no continuity.
Figure 124) to transmission ECM J2
(WP 0009, Figure 112).
Proceed to step 3.
No Continuity - Rear chassis wiring
harness is shorted, replace rear chas-
sis wiring harness (WP 0188).
Connect the cab lower wiring harness
connector P-C39 (WP 0009, Figure
70) to implement ECM J-2 (WP 0009,
Figure 71) (WP 0268).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Proceed to step 3.
3. Using the MSD (WP 0006), select
1471-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1471-03 is not active.
1471-03 Code Not Active - Trouble-
shooting complete.
Test Step 5. Test for Open Rear
Chassis Wiring Harness.
1. Connect jumper wire between P-
C51 terminal 2 and terminal 4
(WP 0009, Figure 118).
2. Disconnect the rear chassis wir-
ing harness connector FA-C20
(WP 0009, Figure 113) (WP 0154)
from transmission ECM J1 (WP
0009, Figure 112).
0019-11