TM 5-3805-293-23-1
0019
Table 1. Transmission Code (1471-02 to 1961-04) Troubleshooting Procedures - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1471-03 Steering Control
6. Using digital multimeter, measure
Voltage OK (7.2 - 8.8 Volts) - Sensor
Position Sensor #1 Voltage
voltage between P-C51 terminal 2
signal circuit, transmission and imple-
Above Normal - Continued
(WP 0009, Figure 118) and termi-
ment ECM OK. Replace LH joystick
nal 8 (ground).
(WP 0282).
Proceed to step 7.
Voltage Not OK - Sensor signal cir-
cuit open or transmission or imple-
ment ECM bad, proceed to Test Step
3.
7. Using the MSD (WP 0006), select
1471-03 Code Active - Repeat trou-
Trans/chassis 120M and verify
bleshooting code from the beginning.
1471-03 is not active.
1471-03 Code Not Active - Trouble-
shooting complete.
Test Step 2. Test for Open Cab
Lower Wiring Harness to 8 Volt
Power Supply.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Connect jumper wire between P-
C51 terminal 1 and terminal 8
(WP 0009, Figure 118).
3. Disconnect the cab lower wiring
harness connector P-C41 (WP
0009, Figure 68) from implement
ECM J-1 (WP 0009, Figure 69)
(WP 0268).
4. Using digital multimeter, measure
Resistance Less Than 5.0 Ohms -
resistance between P-C41 (WP
Replace implement 1 ECM (WP
0268).
0009, Figure 68) terminal 44 and
terminal 45 (WP 0009, Figure 18).
Remove jumper wire between P-C51
Resistance should be less than 5.0
terminal 1 and terminal 8 (WP 0009,
ohms.
Figure 118).
Connect the cab lower wiring harness
connector P-C51 (WP 0009, Figure
118) to LH joystick connector J-1 (WP
0009, Figure 119) (WP 0282).
Proceed to step 5.
Resistance 5.0 Ohms or Greater -
Replace cab lower wiring harness
(WP 0266).
Proceed to step 5.
0019-9