TM 5-3805-293-23-1
0014
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2293-06 Left Front Drive
Connect AF-C4 (WP 0009, Figure 96)
Motor Solenoid Current
on left front drive motor solenoid (WP
Above Normal - Continued
0009, Figure 97).
Install nose front frame cover on
machine (WP 0224).
Proceed to step 5.
Continuity - Replace cab lower wiring
harness (WP 0266).
Connect AF-C4 (WP 0009, Figure 96)
on left front drive motor solenoid (WP
0009, Figure 97).
Install nose front frame cover and rear
front frame cover on machine (WP
0224).
Proceed to step 5.
5. Using the MSD (WP 0006), select
2293-06 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2293-06 is not active.
2293-06 Code Not Active - Trouble-
shooting complete.
2293-13 Left Front Drive
System Response:
Motor Solenoid Out of Cali-
All-Wheel Drive (AWD) Electronic
bration
Control Module (ECM) will log a diag-
nostic code and a warning will appear
on the messenger while the diagnos-
tic code is Active.
N OT E
Always inspect the harness connectorsthat are involved in the circuit.
Poor connections can often be the cause of a problem in an electrical
circuit. Verify that all connections in the circuit are clean and secure,
and that all connections are in good condition. If a problem with a
connection is found, correct the problem and verify that this diagnostic
code is Active before performing this procedure.
Perform open or short circuit test ateach harness connection to identify
correct harness to replace.
Perform this test only if condition is Active.
Test Step 1. Check for Other Active
Codes in All Wheel Drive 120M
ECM.
1. Connect MSD (WP 0006). Select
All Wheel Drive 120M and verify
2293-13 is active.