TM 5-3805-293-23-1
0013
Table 1. All-Wheel Drive (AWD) Code Troubleshooting - Continued.
CDI FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2190-05 Right All-Wheel
3. Remove rear front frame cover
Drive (AWD) Clutch Forward
from machine (WP 0224).
Solenoid Current Below Nor-
4. Disconnect clutch drive solenoid
mal - Continued
AF-C3 harness connector (WP
0009, Figure 51) from cab lower
wiring P-C34 harness connector
(WP 0009, Figure 52) (WP 0200).
5. Connect jumper wire between P-
C34 terminal 4 and P-C34 termi-
nal 22 (WP 0009, Figure 52).
6. Turn battery disconnect switch
and ignition switch to the ON posi-
tion.
7. Check for Active code 2190-05 or
Code 2190-05 Remains Active - Pro-
2190-06 in All Wheel Drive 120M
ceed to Test Step 3.
ECM (WP 0006).
Code 2190-05 Becomes Inactive
and 2190-06 Becomes Active -
Remove jumper wire from P-C34 ter-
minal 4 and terminal 22 (WP 0009,
Figure 52).
Replace clutch drive solenoid harness
(WP 0224).
Proceed to step 8.
8. Using the MSD (WP 0006), select
2190-05 Code Active - Repeat trou-
All Wheel Drive 120M and verify
bleshooting code from the beginning.
2190-05 is not active.
2190-05 Code Not Active - Trouble-
shooting complete.
Test Step 3. Test L948-OR Right
AWD Clutch FWD Sol Circuit for
High Resistance or Open in Cab
Lower Wiring Harness.
1. Turn ignition switch and battery
disconnect switch to the OFF
position.
2. Remove jumper wire from P-C34
terminal 4 and terminal 22 (WP
0009, Figure 52).
3. Disconnect cab lower wiring P-
C37 harness connector (WP
0009, Figure 55) from AWD ECM
J2 (WP 0009, Figure 56) (WP
0270).
0013-79