TM 5-3805-293-10
0005
ALL-WHEEL DRIVE (AWD) CONTINUED
5. Turn AWD Control Dial to desired speed.
a. Turn control dial counterclockwise to decrease front wheel speed. Placing the dial in the full
counterclockwise position will bring the machine to a stop.
b. Turn the control dial to the center (detent) position to set front wheel speed at 2.5 mph (4 km/h).
c.
Turn the control dial clockwise to increase front wheel speed. Placing the dial to the full clockwise position
will set front wheel speed to a maximum of 5 mph (8 km/h).
6. Depressing transmission modulator control (inching pedal) proportionally reduces front wheel speed.
a. With pedal fully depressed, machine comes to a stop.
b. With pedal partially released, machine is propelled at speed in proportion to amount pedal is released, up
to speed set on AWD Control Dial.
c.
With pedal fully released, machine is propelled at speed set on AWD Control Dial.
Operating Machine in MANUAL Mode
0005
1. Before turning AWD Mode switch to MANUAL position, the machine must meet the following conditions:
a. Actual gear is anything but NEUTRAL, eighth gear FORWARD, or sixth gear REVERSE.
b. Engine running.
c.
Parking brake switch set to DISENGAGED position.
d. Inching pedal not fully depressed.
2. Turn AWD Mode switch to MANUAL position. AWD indicator will illuminate.
N OT E
While in MANUAL mode, amount of speed commanded to front wheels is affected by
available traction.
Transmission gear is also used to limit aggression. Aggression will be limited to
100 percent in gears above fifth FORWARD and above fourth REVERSE.
3. Turn AWD Control Dial to desired speed.
a. Turning the dial to the full counterclockwise position (negative aggression) front wheels will turn at
99 percent of rear wheel speed.
b. Turn the control dial to the center (detent) position to set front wheel speed at 100 percent of rear wheel
speed.
c.
Turning the dial to the full clockwise position (positive aggression) will set front wheel speed at 120 percent
of rear wheel speed.
4. Depressing transmission modulator control (inching pedal) proportionally reduces front wheel speed.
a. With pedal fully depressed, machine comes to a stop.
b. With pedal partially released, machine is propelled at speed in proportion to amount pedal is released, up
to speed set on AWD Control Dial.
c.
With pedal fully released, machine is propelled at speed set on AWD Control Dial.
END OF TASK
0005-31
