3304 VEHICULAR ENGINESSPECIFICATIONSTM 5-3805-263-14&P-2FLYWHEEL HOUSINGFace Runout (axial eccentricity) of the Flywheel Housing:1. Fasten a dial indicator to the crankshaft flange so the anvil of theindicator will touch the face of the flywheel housing.2. Put a force on the crankshaft toward the rear before reading theindicator at each point.3. With dial indicator set at .000 in. (0.0 mm) at location (A), turn thecrankshaft and read the indicator at locations (B), (C) and (D).4. The difference between lower and higher measurements takenall four points must not be more than .012 in. (0.30 mm), which isthe maximum permissible face runout (axial eccentricity) of theflywheel housing.1-249
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
