GOVERNOR - TM-5-3805-263-14P-2

FUEL INJECTION PUMP HOUSING CONT. CONT. - TM-5-3805-263-14P-2_155

GOVERNOR CONT. - TM-5-3805-263-14P-2_157

TM-5-3805-263-14P-2 Grader Heavy Road Motorized Type I Nonsectionalized Type II Sectionalized Manual
Page Navigation
141

ENGINE TM 5-3805-263-14&P-2 GOVERNOR DISASSEMBLE GOVERNOR Tools Needed A B C 1P510 Driver Group 1 1P1855 Snap Ring Pliers* 1 6V2163 Clamp Assembly Spring Compressor* 1 *Part of 6V4095 Tool Group. start by: a) remove fuel injection pump housing and governor b) remove fuel transfer pump NOTE: If it is desired to remove only the governor so the fuel injection pump housing can be disassembled, do only Steps 1, 2, 15, 21, 25, 26, 27, 28, 31, 33, 34 and 37. 1. Remove bolts ( 1) and remove fuel ratio control (2). Remove the fuel shutoff solenoid. 2. Remove six bolts (3) two top bolts (4). housing (5) and the gasket. 3. Remove governor spring (6) the two wave washers, one flatwasher and seat from the guide in the housing. 4. Make a mark of the position of lever (7) on shaft (8). Loosen bolt (10). Use a chisel or screwdriver to cause expansion of lever (7) so it can be removed from shaft (8). DISASSEMBLY AND ASSEMBLY 1-146

Privacy Statement
Press Release
Contact