TM 5-3805-263-14&P-12.Set the blade with the left end in line with the outeredge of the left front tire. Tilt the moldboard so the top ofthe blade is slightly ahead of the cutting edge.3.Raise the right lift cylinder to high position. Angle theblade to deliver the material inside the right rear wheels.4.Lower the left lift cylinder to set the blade tip for thedesired depth of cut.5.Lean the wheels to the right. Make a shallow, 50 to100 mm (2 to 4 in), marking pass.6.Keep the left front tire in the bottom of the ditch.Continue ditching to the desired depth.62
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
