TM 5-3805-263-14&P-1
Right Hand "V" Ditching
Be sure to ground moldboard before retracting
centershift lock pin.
NOTICE
Position the frame straight. If the machine is articulated,
the tire sidewalls may be forced against the back slope,
causing tire sidewall damage and also force dirt between
the tire and rim, causing air loss and flat tires.
1.
Set the centershift lock pin as shown. Move the
centershift lock pin lever to the INDEX and RUN position
2.
Set the blade with the right end in line with the outer
edge of the right front tire Tilt the moldboard so the top of
the blade is slightly ahead of the cutting edge.
3.
Raise the left lift cylinder to the high position. Angle
the blade to deliver the material inside the left rear
wheels.
4.
Lower the right lift cylinder to set the blade tip for
desired depth of cut.
60
