TM 5-3805-263-14&P-3
Moldboard- Wear Strips
Machine must be level, implements lowered,
parking brake applied.
When the wear between moldboard (1) and wearstrip (2)
1. Lower the moldboard to the ground and apply a
becomes excessive, replace the wearstrips.
slight down pressure. Stop the engine.
5. Install the retaining plate.
6. There are four wearstrips to be replaced. Two on
each side.
7. Replace the remaining wearstrips using the above
procedures.
2. Remove the bolts from the plate and remove the
plate.
3.
Remove the worn wearstrips.
4. Install the new wearstrips.
5-29
