TM 53805-263-14&P-3
DISASSEMBLY AND ASSEMBLY
SCARIFIER SLEEVE AND LINK ASSEMBLY
8.
Remove the sleeve assembly (2) with the cap (4)
assembly (2) and position on the ballstud of the
and shims from the ball stud on the arm assembly
drawbar (6).
(8).
5.
Install the pin assembly (1) in the sleeve assembly
9.
Inspect the cap and ball fittings (7) on the sleeve
(2).
assembly (2).
6. Install cap (4) loosely on the link assembly
10. Repeat steps 1 through 9 for the other sleeve and
(5) with the 2 bolts and washers.
link assembly.
7.
Install shims.
INSTALL SCARIFIER SLEEVE AND LINK
NOTE: Tighten the bolts evenly until the ball on the
ASSEMBLY
drawbar is in contact with the link and cap. Measure the
clearance between the link and cap with an 8H8581
1.
Hold the sleeve assembly (2) against the ballstud at
Feeler Gauge. Install enough shims to make up the
the arm assembly (8).
measured clearance plus .030" + .015 "(.76 + .38).
2.
Loosely install the cap (4) on the sleeve assembly
8.
Tighten the nut and bolt (3) on the lug located at the
(2) with the 2 bolts and washers.
bottom of the sleeve assembly (2).
3.
Install shims.
9.
Repeat steps I through 8 for the other sleeve and
link assembly.
NOTE: Tighten the bolts evenly until the ball on the arm
is in contact with the sleeve and cap. Measure the
end by:
clearance between the sleeve and cap with an 8H8581
a) remove blocks supporting scarifier drawbar.
Feeler Gauge. Install enough shims to make up the
measured clearance plus .030" + .015" (.76 + .38).
4.
Insert the link assembly (5) into the sleeve
3-284
