TM 5380-263-14&P-3
DISASSEMBLY AND ASSEMBLY
STEERING PUMP
4. Put O-ring seal (8) in position in body and install
bushing (7) and spiral snap ring (6).
5. Put spool (9) in position in sleeve (12). Install pin
(10) that holds the spool in the sleeve.
6. Install springs (11) in spool (9) and sleeve (12).
Make sure the curves of the springs are in contact
and in the center of the spool.
7. Put race (13), bearing (14) and race (15) in
position in body.
8. Install sleeve assembly (16) in body.
9. Put spacer (17) in position on the body. Put drive
(18) in position over pin (10). Put gear (19) and
spacer (20) in position over gear for drive (18).
NOTE: Pin (10) in the sleeve assembly must be in
alignment with gear (19) as shown.
10. Put outer gear (21) and cap (22) in position.
3-170
