SUPPLEMENTAL STEERING SYSTEM
TM 5-3805-263-14&P-3
DUMP VALVE SWITCH
(9G2795)
Adjustment of dump valve switch (1)'
(Dump valve in normally closed position)
1. Loosen nut (2) holding switch to bracket.
2. Move switch vertically up or down until roller is located in
lower
half of slot (notch) (3) of dump valve pin (4).
3 Tighten nut (2) holding switch to bracket.
4. Loosen nut (5) holding bracket to floor plate.
5 Move bracket horizontally until switch roller is just touching
bottom of slot (3) in dump valve pin (4).
6. Tighten nut (5) holding bracket to floor plate.
7. With continuity tester across switch terminals, depress
dump
valve pin (4). Tester should indicate open (no continuity).
Torque for nut (2) ...........................................20 Nm (15 1 lb ft.)
SWITCH (GOVERNOR)
(3T3132)
Adjustment of governor switch (1)'
1. Pull up accelerator pedal to the engine shut-off position.
2. Loosen locknut (2) for adjusting screw (3).
3 With continuity tester across switch terminals, turn adjusting
screw (3) in until tester shows continuity.
4. Rotate screw (3) one more revolution (past switch actuation
point)
5. Tighten locknut (2).
Torque for switch locknut (4) ..................... 20 2 N-m (15 1 lb ft.)
RELIEF VALVE
Para 17-27
(4T1056)
Pressure to open valve ............... 12600 + 700 kPa (1825 100 psi)
3-59/(3-60 Blank)
