TM 5-3805-261-34
FRONT AXLE MAINTENANCE.
14-15. Leaning Wheel Cylinder. (Sheet 4 of 4)
ASSEMBLY
6.
Install items 12 thru 7 as an assembly on
rod (14, Figure 14-118).
7.
Using seal expander, install new seal
assembly (5) and ring (4) on piston (6,
Figure 14-117).
8.
Install items 6 thru 4 as an assembly to rod
(14, Figure 14-116).
9.
Using thread lubricant, lubricate threads of
bolt (2). Install washer (3) and bolt (2).
Tighten to 720 to 880 ft-lb. torque.
10. Using hydraulic fluid, lubricate outside of
head (7) and inside of cylinder (1, Figure
14-115).
11. Install cylinder (1).
NOTE
Tighten crown with rod fully extended. This
will keep cylinder, piston and head in
alignment.
12. Using suitable chain wrench, tighten crown
(13) on cylinder (1). Tighten crown (13) to
350 to 550 ft-lb. torque.
NOTE
Return 130C Grader to
original equipment condition.
End of Task
14-87
Figure 14-116.
Figure 14-117.
Figure 14-118.
