TM 5-3805-261-34
FRONT AXLE MAINTENANCE. (cont.)
14-15. Leaning Wheel Cylinder. (Sheet 3 of 4)
DISASSEMBLY (cont.)
6.
Remove and discard ring (8), preformed
packing (9) and seals (10 thru 12) from
head (7, Figure 14-119).
7.
Remove crown (13) from rod (14, Figure
14-120).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
ASSEMBLY
1.
Using hydraulic fluid, lubricate inside of
crown (13, Figure 14-120).
2.
Install crown (13) on rod (14).
3.
Using clean oil, lubricate new seals (12 thru
10), new preformed packing (9) and new
ring (8).
4.
Using seal installer, install new seals (12
thru 10, Figure 14-119) in head (7). Lip of
seal (11) is toward inside of head (7). Lip of
seal (10) is toward outside of head (7).
5.
Install new preformed packing (9) and new
ring (8) to head (7).
Figure 14-119.
Figure 14-120.
Go to Sheet 4
14-86