TM 5-3805-261-34
TRANSMISSION MAINTENANCE.
14-13. Transmission Oil and Scavenge Pump. (Sheet 3 of 4)
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
ASSEMBLY
1.
Install ball (27), two dowels
(26) and gears (25) to manifold
(28, Figure 14-114).
2.
Install two bearings (24) to manifold (20, Figure 14-113).
Joint in bearing (24) must be at an angle 15 to 45 degrees
to a vertical line through centers of bores for gears and to
a depth of 0.062 inch from face of manifold
(28).
3.
Install two new seals (23).
4.
Install gear (22) in manifold (20) and key (21) in gear (22).
5.
Install manifold (20) to manifold (28).
6.
Install gear (19).
7.
Install four dowels (18) and body (17, Figure 14-112).
8.
Install two bearings (16) and new seal (15). Joint in
bearing (16) must be at an angle 15 to 45 degrees to a
vertical line through centers of bores for gears and to a
depth of 0.062 inch from face of manifold (28).
Figure 14-113.
Figure 14-112.
Figure 14-114.
Go to Sheet 4
14-81
