TM 5-3805-261-34
WHEEL AND TIRE MAINTENANCE.
7-2.
Tire Removal. (Sheet 5 of 5)
INSTALLATION
10.
Check to see that valve core is still not installed,
then attach a pneumatic tire inflator-gage to
valve stem (10, Figure 7-6).
WARNING
TIRE INFLATION
Stand behind tread when inflating tires.
Ensure that tires are properly seated on
rims. Correct pressure is 35 psi.
Improperly seated and overinflated tires
can burst with explosive force. Failure
to follow these procedures may cause
INJURY. If injured, seek medical aid
immediately.
11.
Inflate tire (11) to 35 psi. You may have to
compress tire (11), using chains and cable hoist
to get the beads to seat.
12.
Remove air chuck and exhaust air from tire.
13.
Install valve core (2, Figure 7-7).
14.
Inflate tire (11) to 35 psi, observing WARNING
which precedes step 11.
15.
Install valve cap (1).
NOTE
Return 130G Grader to original
equipment condition.
End of Task
7-7/(7-8 blank)
Figure 7-7.
Figure 7-6.
