TM 5-3805-261-34
WHEEL AND TIRE MAINTENANCE.
7-2.
Tire Removal. (Sheet 3 of 5)
REMOVAL
7.
Attach hoist and sling to items 6 thru 11 as an
assembly, lift up, turn over and lower to work area
with inside of wheel facing upward. Remove hoist
and sling.
8.
Using sledge hammer, remove items 7 thru 11 as
an assembly from tire (6) and set down on work
surface with stem (10, Figure 7-2) facing upward.
9.
Remove spud (7), grommet (8), nut (9) and valve
stem (10) from wheel (11, Figure 7-3). Discard
grommet (8).
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Install valve stem (10), nut (9), new grommet (8)
and spud (7) to wheel (11, Figure 7-3).
CAUTION
Do not use soap or detergent solutions to
lubricate tire.
2.
Apply rubber lubricant to inside bead of tire (6,
Figure 7-2).
Go to Sheet 4
7-5
Figure 7-3.
Figure 7-2.
