TM 5-3805-261-34
TRANSMISSION MAIENANCE. (cont)
5-4.
Transmission Control Lever and Busing. (Sheet 5 of 9)
REMOVAL (cont)
28.
Remove key (61) and bearing (62) from shaft (63,
Figure 5-13).
29.
Remove bolt (64), washer (65) and items 66 thru 68
as an assembly (Figure 5-14).
30.
Remove key (66) and bearing (67) from shaft (68,
Figure 5-15).
31.
Remove two bearings (69), rings (70), levers (71
and 72) from housing (73, Figure 5-16). Tag levers
(71 and 72) as to their location in housing (73) to aid
in installation.
CLEANING
Clean all parts. Refer to Chapter 2.
INSPECTION
Inspect all parts. Refer to Chapter 2.
INSTALLATION
1.
Position levers (72 and 71) in housing (73, Figure
5-16) on right side of operator’s compartment.
2.
Install two rings (70) and bearings (69).
3.
Install bearing (67) and key (66) on shaft (68,
Figure 5-15).
Go to Sheet 6
5-12
Figure 5-16.
Figure 5-15.
Figure 5-14.
Figure 5-13.
