TM 5-3805-261-34
TRANSMISSION MINTENANCE.
5-4.
Transmission Control Lever and Housing. (Sheet 2 of 9)
REMOVAL
1.
Remove three bolts (1), washers (2), cover (3) and
gasket (4, Figure 5-1) from right side of operator’s
compartment. Discard gasket (4). Remove all material
from mounting surfaces.
2.
Loosen nut (8).
3.
Remove bolt (5) and washer (6).
4.
Remove rod end (7) and nuts (8 and 9).
5.
Loosen nut (13, Figure 5-2).
6.
Remove bolt (10) and washer (11).
7.
Remove rod end (12) and nuts (13 and 14).
NOTE
All wire, cable and harness assemblies
must
be tagged before disconnecting to
aid in installation.
8.
Remove cables (15 and 16) through cab floor.
9.
Remove washer (17), nut (18), washer (19) and
nut (20).
10.
Remove two bolts (21), washers (22), spacers
(23) and mountings (24) from support (42, Figure
5-3).
11.
Remove two bolts (25), washers (26) and nuts (27).
Go to Sheet 3
5-9
27
Figure 5-3.
Figure 5-2.
Figure 5-1.
