TM 5-3805-261-34COOLING SYSTEM MAINTENANCE.3-34.WaterPump. (Sheet 9 of 9)ASSEMBLY16. Soak new seal (9) in cold, clean water for 30seconds and lubricate new seal (9, Figure 3-182).17. Using seal installer tool, install new seal (9) onshaft (16) until seal (9) touches new seal (18).18. Install new spring (8) on new seal (9).19. Position impeller (7) on shaft (16, Figure 3-181).20. Install washer (6) and bolt (5). Tighten bolt (5) to28 ft-lb torque.21. Position new gasket (4) and cover (3, Figure 3-179).22. Install two washers (2) and bolts (1).NOTEReturn 130G Grader to original equipmentcondition.Figure 3-182.Figure 3-181.Figure 3-179.End of Task3-201/(3-202 blank)
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
