TM 5-3805-261-34
COOLING SYSTEM MAINTENANCE. (cont)
3-34.
Water Pump. (Sheet 8 of 9)
ASSEMBLY (cont)
11.
Install washer (11) and bolt (10, Figure 3-184).
Tighten bolt (10) to 71 ft-lb torque.
12.
Remove strap wrench from driven gear (13).
CAUTION
Clean water only is permitted for use as a
lubricant for assistance at installation.
Do not damage or put hands on the wear
surfaces of rings and seals.
13.
Install new ring (17), smooth side facing new seal
(18, Figure 3-196).
14.
Soak in clean, cold water for 30 seconds and lubricate
new seal (18).
15.
Using seal installation tool, install new seal (18) on
shaft (16) and seat counterbore of housing (22).
Go to Sheet 9
3-200
Figure 3-196.
Figure 3-184.
