TM 5-3805-261-23-2
FRONT AXLE ASSEMBLY REPLACEMENT - CONTINUED
0300 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Use pulling adapter, hydraulic puller, hydraulic pump, washer, screw, and nut, to install two new bearings (14) 0.282 in.
(7.16 mm) from each surface of front axle assembly (3).
2.
Use driver to install two new seals (13) with lips toward outside surface, even with outside surface of axle (3).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Front axle assembly weighs 1,220 lb (553 kg).
3.
Attach sling to front axle assembly (3).
4.
Position front axle assembly (3) on machine.
5.
Install washer (8) and pin (5). Install washer (7) only if required to obtain a maximum gap of 0.06 in. (1.5 mm) between
front axle assembly (3) and machine frame. Hole in pin must align with hole in front axle assembly (3).
6.
Install washer (12) and pin (10). Hole in pin must align with hole in front axle assembly (3).
0300 00-5
