TM 5-3805-261-23-1
LEANING WHEEL HOSES AND FITTINGS REPLACEMENT - CONTINUED
0224 00
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install new preformed packing (43), elbow (42), new O-ring (41), new preformed packing (46), new O-ring (45), and
elbow (30) on leaning wheel hydraulic cylinder (44).
2.
Connect hoses (38 and 40).
3.
Install new tie strap (39).
4.
Install new preformed packing (32), connector (33), new O-ring (37), new preformed packing (34), connector (35), and
new O-ring (36).
5.
Install hoses (38 and 40) to bottom of leaning wheel check and relief valve (31).
6.
Install new preformed packing (25), elbow (26), new
20
preformed packing (24) and elbow (23).
19
7.
Install new O-rings (29 and 22) on elbows (26 and 23).
18
8.
Position hoses (1 and 2) on frame and connect to
elbows (26 and 23).
9.
Install clip (21), washer (27), and bolt (28) on frame.
10.
Install clamp (20), washer (18), and bolt (19) on right-
forward section of frame.
397-755
0224 00-5