TM 5-3805-261-23-1
LEANING WHEEL CYLINDER REPLACEMENT - CONTINUED
0156 00
REMOVAL - CONTINUED
NOTE
5
Some machines have O-rings between
hose assemblies (1 and 5) and elbows (4
6
and 6). Remove and discard O-rings if
7
present.
3.
Remove hose assembly (1), elbow (4), and preformed
packing (3). Discard preformed packing.
397-4202
4.
Remove hose assembly (5), elbow (6), and preformed
packing (7). Discard preformed packing.
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during proce-
dure. Ensure that any lifting device used is in good condition and of suitable load capacity. Keep clear of
heavy parts supported only by lifting device. Failure to follow this warning may cause injury or death to per-
sonnel.
NOTE
Cylinder weighs 55 lb (25 kg).
5.
Install sling on cylinder assembly (8).
6.
Remove bolt (12), washer (11), and retainer (10).
7.
Remove two bolts (14), washers (13), lock (15), and pin (9).
8.
Remove cylinder assembly (8) from machine and set on wood blocks.
9
SLING
SLING
15
10
11
13
14
8
12
397-4204
397-4203
9.
Remove sling.
0156 00-3