TM 5-3805-261-23-1
TRANSMISSION MODULATION CONTROL MAINTENANCE - CONTINUED
0148 00
REMOVAL - CONTINUED
NOTE
Washer is attached to boot with adhesive. Do not separate washer from boot unless replacement of either
part is necessary.
2.
Lift up left-front corner of rubber floor mat (7),
5
remove boot (5) and washer (6) assembly from lever
(4) and return floor mat to original position.
6
4
397-436
7
3.
Remove lower end of spring (9) from bolt (8) fastened
to cab floor frame weldment on outside of machine,
4
under left side of cab.
4.
Remove upper end of spring (9) from lever (4) and
remove lever.
9
8
397-437
CLEANING AND INSPECTION
Clean and inspect all parts in accordance with WP 0020 00.
INSTALLATION
1.
Install lever (4) and connect upper end of spring (8) to lever.
2.
Install lower end of spring (9) on bolt (8) fastened to cab floor frame weldment on outside of machine, under left side of
cab.
3.
If boot (5) or washer (6) required replacement, attach boot (5) to washer (6) with adhesive.
4.
Lift up left-front corner of rubber floor mat (7), install boot (5) and washer (6) assembly over lever (4) and return floor
mat to original position.
0148 00-2
