TM 5-3805-261-23-1
ELECTRICAL GENERAL MAINTENANCE INSTRUCTIONS - CONTINUED
0021 00
RECEPTACLE CONNECTOR REPAIR
0021 00
1.
Using removal tool, insert tool into front of connector (15) and depress locking tab of receptacle (20).
2.
Push wire (16), with receptacle (20) attached, through front of connector (15).
3.
If defective, remove receptacle (20) from wire (16) by cutting through wire just behind receptacle.
NOTE
Perform steps 4 through 7 only if receptacle was removed.
4.
Slide connector (15) back on wire (16).
15
16
17
18
19
20
397-2416
5.
Using wire stripping tool, strip insulation of wire (16) to expose in. (6 mm) length of metal strands (17).
6.
Using crimping tool, securely crimp tabs (19) of receptacle (20) over metal strands (17).
7.
Using crimping tool, crimp tabs (18) of receptacle (20) over insulation of wire (16).
8.
Slide connector (15) forward over receptacle (20) until locking tab of receptacle snaps into place.
WATERPROOF CONNECTOR REPAIR
0021 00
1.
Remove end cover (27) and gasket (26) from front of connector (25).
2.
Remove seal (21) from rear of connector (25) and slide seal back on wire (22).
25
21
24
23
26
22
27
397-2417
NOTE
Perform the following steps for each wire of connector.
Tag wires to aid in installation.
3.
Using pin removal tool, insert tool into front of connector (25) and depress locking tab of connector.
4.
Remove wire (22) with pin (24) from rear of connector (25).
5.
If defective, remove pin (24) from wire (22) by cutting through wire just behind pin.
0021 00-5
