TM 5-3805-261-23-1
ELECTRICAL SYSTEM TROUBLESHOOTING PROCEDURES - CONTINUED
0008 00
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
2.
40. Windshield Wiper Will Not
Operate or Will Not Operate
motor.
in High Speed or Low Speed
Position (CCE Machine) -
a. Place battery disconnect switch in
Continued.
OFF position.
b. Completely disconnect wiper
switch wiring.
(Ω) range.
d. Connect meter positive lead to one
end of each of the 3 wires. Connect
meter negative lead to other end of
each wire. Observe meter.
problem still exists, go to Test 3.
3.
Test wiper switch source voltage.
a. Place battery disconnect switch in
OFF position.
b. Completely disconnect wiper
switch wiring.
c. Set multimeter to appropriate
voltage range.
d. Connect meter positive lead to
black wire. Connect meter negative
lead chassis ground.
1. If voltage is indicated, replace wiper
e. Place battery disconnect switch in
ON position. Observe meter
reading.
2. If voltage is not indicated, repair open
the problem still exists, go to Test 4.
4.
Test wiper motor ground for
continuity.
a. Place battery disconnect switch in
OFF position.
b. Completely disconnect wiper
motor wiring.
(Ω) range.
d. Connect meter positive lead to
wiper motor ground wire. Connect
meter negative lead to chassis
ground.
0008 00-36