TM 5-3805-261-20
HYDRAULIC SYSTEM MAINTENANCE.
15-13.
Centershift Check Valve. (Sheet 4 of 4)
INSTALLATION
5.
Install new preformed packing (10) and
connector (9, Figure 15-18).
6.
Install new preformed packing (8) an
connector (7).
7.
Connect hose assemblies (6 and 5).
WARNING
Only a qualified operator may perform
the
next
procedure.
All
other
personnel must clear the immediate
area. Failure to follow this procedure
may cause INJURY. If you are
injured, seek medical aid immediately.
8.
Start engine. Refer to TM 5-3805-261-10.
9.
Operate circle centershift control lever.
Move system through at least five full
movements of travel to bleed air from the
system.
10.
Stop engine.
11.
Inspect hose assemblies and connections
for leaks.
12.
Refill hydraulic tank to proper level. Refer to
LO 5-3805-261-12.
13.
Install frame cover (4), nine washers (3 and
2) and bolts (1).
NOTE
Return
130G
Grader
to
original
equipment condition.
Figure 15-18.
End of Task
15-45